V grafickém prostředí to nešlo.
Tak na příkazové řádce.
To change a dynamic disk back to a basic disk using a command line
- Back up all volumes on the disk you want to convert from dynamic to basic.
- Open a command prompt and type
diskpart
. - At the DISKPART prompt, type
list disk
. Make note of the disk number you want to convert to basic. - At the DISKPART prompt, type
select disk <disknumber>
. - At the DISKPART prompt, type
detail disk <disknumber>
. - For each volume on the disk, at the DISKPART prompt, type
select volume= <volumenumber>
and then typedelete volume
. - At the DISKPART prompt, type
select disk <disknumber>
. Specify the disk number of the disk that you want to convert to a basic disk. - At the DISKPART prompt, type
convert basic
.
Zdroj:
Žádné komentáře:
Okomentovat